The difficulty of making silicone folding cups is to fold the spacing points, and other shapes other than arcs are difficult to achieve the folding effect. The drawings mainly depend on the wall thickness of the folding position. Generally, the wall thickness of the folding part needs to be as small as The thickness that can be bent back and forth can achieve a gradual gradient size. Usually, the wall thickness of the folded position is between 0.5-1mm. The folding position can be determined according to the size of the silicone water cup. Finally, the folding effect is achieved by the strength of the folded part. .
Making molds also requires certain skills. When opening the mold, the upper and lower mold clamping interfaces should be in the smallest position. The slope of the product should be judged according to the taper size of the mold, and the minimum should be achieved to achieve the folding effect. The more common The problem is that the inside of the silicone folding cup is easily affected by the wall thickness of the folding part, so its internal folding point must be made into a structure that slopes from top to bottom or from bottom to top, so that there will be no extrusion expansion during folding. The problem.
Post time: May-31-2022